Page 1 of 2
Next
Mine had tinned ends as opposed to wire ferrules like in the picture. I switched mine to the ferrules.
I believe you need the smaller wheel here. The large one didn’t clear,
On my kit the AC Power cables were not crimped with the required Spade and Ferrules. The Heater AC cable did not have the spade lg and Ferrules either.
This the long unlabeled sleeve.
I had to use M3 25mm here instead of M3 22mm
For the Revo fan shroud there was no nut and I needed a M3 25mm instead of the M3 20mm
Screw is actually 6mm as supplied in my kit.
M3 8mm were a bit long M3 6mm would be flush.
M3 22mm was too short went with M3 25mm.
I had to use 2 M3x 10mm, the 8mm wasn’t long enough to bite into the nut.
Page 1 of 3
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
Mine had tinned ends as opposed to wire ferrules like in the picture. I switched mine to the ferrules.
I believe you need the smaller wheel here. The large one didn’t clear,
On my kit the AC Power cables were not crimped with the required Spade and Ferrules. The Heater AC cable did not have the spade lg and Ferrules either.
This the long unlabeled sleeve.
I had to use M3 25mm here instead of M3 22mm
For the Revo fan shroud there was no nut and I needed a M3 25mm instead of the M3 20mm
Screw is actually 6mm as supplied in my kit.
M3 8mm were a bit long M3 6mm would be flush.
M3 22mm was too short went with M3 25mm.
I had to use 2 M3x 10mm, the 8mm wasn’t long enough to bite into the nut.
Page 1 of 3
Next